|
|
For best results dig a three-foot deep
hole that is 9" wide at top and 12" wide at bottom. Put in three
inches of gravel and center post in hole. Use level to straighten and add
three more inches of gravel. Add concrete to within six inches of surface.
Fill hole with soil and mound extra soil around bottom of post to keep
water away from post. Allow concrete to set for 24 hours before attaching
Safe-Fence Tensioners.
Mark, dig, and set in all of your support posts. These
will be used on all gate, ends, corners, changes in elevation (low and
high spots), and in spans exceeding 825 ft. to hold tension. We recommend
4"x4" square or 5"+ round or larger pressure treated post.
These should be set a minimum of 3 ft. in the ground with concrete.
For a very attractive fence, use nominal 4"X4"
pressure treated posts covered by SAFE-FENCE
R-4005 Wood Post Vinyl Sleeves.
|
